Description
Features:
- A two pack waterbased clear coat that can be applied to painted and unpainted surfaces to allow easy removal of graffiti.
- The clear coat forms a very hard, glossy, UV protectant finish that allows solvent removal of the graffiti.
- Most graffiti can be removed, although there are some felt tip pens that will stain the surface and may leave ghosting on the surface
- Full graffiti proof properties within 12 hours of application
Application:
- Can be applied with a brush, pad applicator or spray.
- Do not use a roller as this may cause foaming.
- The product is ready for use but if thinning is required use water.
- Apply two coats at a spread rate of 12 – 14 square metres per litre.
Surface Preparation:
- On previously painted surfaces thoroughly clean the surface to remove dirt, grease and oil.
- Lightly sand glossy surfaces.
- If repainting or painting a new surface apply the required colour using Vipond’s Acrylic Low Sheen and allow at least 12 hours to dry.
- On new brickwork or concrete seal with Vipond’s Concrete and Masonary Sealer.
Mixing:
- To one litre of Graffiti Coat add 12.5 mls of crosslinker.
- Add the crosslinker while gently stirring the Graffiti Coat.
- Leave for 15 minutes then gently stir again before using.
- Only stir gently to minimize aeration of the paint.
- The crosslinked Graffiti Coat will lose its reactivity after 16 hours but can be reactivated with the addition of more crosslinker
Drying Time:
- Under normal drying conditions (above 14°C and low humidity) it will be touch dry within 30 minutes and can be recoated after 2 hours.
- Do not apply if the temperature is below 10°C.
Coverage:
- 14 square metres per litre per coat
Cleaning and Thinning:
- Use clean water only
Removing Graffiti:
- Use Viponds Graffiti Cleaner to remove graffiti.
- After removing graffiti several times the clear coat may be damaged and it is recommended to apply another coat of Graffiti Coat.
- On rough textured surfaces cleaning off graffiti may be difficult
